Page 34 of 80 Instruction Manual for AURORA CDD BCG.00613_AA
Part 4 Operations Guide
4.1 GENERAL CONDITIONS
Before checking the operation of the equipment, it is necessary to have a thorough knowledge of
the instruments and the functions that have been enabled in the installation. The equipment
operates automatically without the aid of an operator; operating state is controlled through the
instruments.
The interpretation or variation of some data is reserved exclusively for
specialized and qualified staff.
During operation, check that the environmental and logistical conditions are correct. Make sure
that the said conditions have not changed over time and that the equipment is not exposed to
adverse weather conditions and has not been isolated with foreign
bodies.
Power-One cannot be held responsible for damage to the equipment or the operator if it is the
result of incompetence, insufficient qualifications or lack of training.
4.2 COMMISSIONING
On completion of the installation and configuration in Part 3, the CDD will be connected to the PC.
The commissioning of the system consists in the acquisition of the MICRO Inverters by the CDD.
This is carried out using a PC or Tablet, connected via a WIFI network or Ethernet cable, to the CDD
local web server.
4.2.1 ACCESSING THE CDD LOCAL WEB SERVER
In order to access the CDD local web server, the PC or Tablet must be connected to the same local
network, i.e. through the same Ethernet or WiFi router, or connected directly to the CDD using a
cross Ethernet cable.
To access the CDD local web server, enter the IP address acquired previously (section 3.4.3.1, IP
Address View) in the URL address bar of your browser, and wait until the Power-One page is
displayed.
To Next Page
Loading...
