Power One Aurora CCD - Storage and Dismantling

Page 76 of 80 Instruction Manual for AURORA CDD BCG.00613_AA
Part 6 Maintenance Guide
6.2 STORAGE AND DISMANTLING
6.2.1 STORAGE OF THE EQUIPMENT OR PROLONGED STOP
If the equipment is not used immediately or is stored for long periods, check that it is correctly
packed and
contact Power-One for storage instructions.
The equipment must be stored in well-ventilated indoor
areas that do not have characteristics that
might damage
the components of the equipment.
Restarting after a long or prolonged stop requires a check and, in some cases, the removal of
oxidation and dust that will also have settled inside the equipment if not suitably protected.
6.2.2 DISMANTLING, DECOMMISSIONING AND DISPOSAL
Power-One CANNOT be held responsible for disposal of the equipment: displays, cables, batteries,
accumulators, etc., and therefore the customer must dispose of these substances,
which are
potentially harmful to the environment, in accordance with the regulations in force in the country o
f
installation.
If the equipment is dismantled, adhere to the regulations in force in the country of destination, and
in any case avoid causing any kind of
pollution in order to dispose of the products listed below.
Table 6- 2: Disposal of Components