63230-319-204A2 PowerLogic™ Ethernet Gateway
12/2008 Setup
© 2008 Schneider Electric. All Rights Reserved.
11
ENGLISH
Web Page Access
Action Result
1. From the Setup page, click Web Page
Access.
Opens the Web Page Access page.
2. In the Ethernet & TCP/IP row, select the
access level (None, Read-only, or Full) that
each user group has for the Ethernet &
TCP/IP web page.
See Table 6 below for an explanation of access
levels for each group.
3. To allow Guest access to the web page,
select Read-only under the Guest column.
NOTE: If the Guest group is Read-only,
other groups may only be set to Read-only
or Full.
Allows the default Guest group to access the
web page.
4. Repeat steps 2 and 3 for the Serial Port,
Device List, Statistics, and Read Device
Registers rows.
Selects the access level for each web page.
5. Click Apply. Saves the password settings.
Table 6: Group Access
Group Access
Administrator Full access to all web pages
NOTE: We recommend that you change the default administrator
password for system security the first time you log in.
Guest Read-only access to selected web pages.
Three user-defined
groups
Choosing from the following options, the administrator assigns web
page access for each group. Access levels are as follows:
• None: a group has no access to selected web page
• Read-only: password grants a group read-only access to the
selected web page
• Full: a group has the same access as the Administrator group to the
selected web page
Figure 9: Web Page Access Page
To Next Page
Loading...
Need help?
General