2
Powerware 9315 (100 kVA--160 kVA) Installation
164200292 REV. E 041500
Using This Manual
The system you are installing dictates which parts of this manual you should read.
Everyone should read Chapters 1 through 4:
· Chapter 1 discusses installation considerations for your entire UPS system.
· Chapter 2 tells you how to prepare your site for the installation of your UPS
system. It discusses equipment environmental requirements, inspecting and
unpacking cabinets, and pallet removal.
· Chapter 3 describes how to install the U PS cabinet.
· Chapter 4 illustrates the two methods for joining cabinets together.
· Chapter 5 contains safety instructions and general notes for installation of the
UPS manufacturer’s optional battery cabinets.
· Chapter 6 contains information for installing the optional input transformer
cabinet.
· Chapter 7 contains information for installing the optional Power Distribution
Module (PDM).
· Chapter 8 discusses installing the optional Remote Emergency Power Off
(EPO) control.
· Chapter 9 contains information for installing the optional remote battery
disconnect.
· Chapter 10 contains information for installing the optional R emote Monitor
Panel (RMP).
· Chapter 11 contains information for installing the optional Relay Interface
Module (RIM).
· Chapter 12 contains information for installing the optional Supervisory Contact
Module (SCM).
· Appendix A contains important information for planning and installing your UPS
system, including illustrations of cabinets and optional accessories.
Read through each installation procedure before you begin. P erform only those
procedures that apply to the UPS system you are installing.
To Next Page
Loading...
