Preface
EGM-4 Operator's Manual – Version 4.19
- 5 -
Preface
It is extremely important that you take the time to review this operator’s manual prior to
installation and operation of the EGM-4 CO
2
Gas Analyzer. Otherwise, damage may be
caused which is not covered under our normal warranty policy. This operator’s manual is
relevant to all EGM-4’s running firmware (EPROM) version 1.30 and higher.
System Calibration
• This product is shipped as a factory calibrated system. System calibration is not
required upon receipt from our factory.
• Familiarization with the documentation and calibration procedures is required prior to
future recalibration. See section 3CAL on page 35 of this manual.
• All calibration related questions may be directed directly to PP Systems at:
Telephone: +1 978.834.0505
Fax: +1 978.834.0545
Email: support@ppsystems.com
User Registration
It is very important that ALL new customers register with us to ensure that our user’s list is
kept up to date. If you are a PP Systems’ user, please register yourself electronically on our
web site at http://www.ppsystems.com/user_registration2.htm .
Only REGISTERED users will be allowed access to our protected “Users” section of our web
site. This section will contain important product information including hardware/software
updates, application notes, newsletters, etc.
Thank you in advance for your cooperation.
The warranty excludes all defects in equipment
caused by incorrect installation, operation or
maintenance, misuse, alteration, and/or
accident.
To Next Page
Loading...
Need help?
General