PPI FLOREX User Manual

Parameter Description
Settings
(Default Value)
This parameter is available and applicable only if the ‘Reset
Command’ for ‘Storage of Minimum & Maximum value of Flow
Rate’ is set to ‘Yes’ on Operator Page. The numeric value entered
for this parameter should match with the numeric value set for the
‘Supervisory Passcode’ for ‘Reset Command’ on Utility Page to
make the ‘Reset Command’ effective. If the value entered for this
parameter does not match with the value set for ‘Supervisory
Passcode’ for ‘Reset Command’ on Utility Page, the ‘Reset
Command’ will not be effective even if it is set to ‘Yes’ and the
previously stored Minimum & Maximum value of Flow Rate will
remain intact.
PASSCODE VALUE
0 to 250
(Default : 0)
No :
If for any reason, the accumulated Flow Total is not to be Reset
yet, issue this as a Command to intact the previously accumulated
values.
Yes :
This Command Resets the previously stored accumulated Flow
Total to 0. The ‘Total Reset Command’ will be effective only if the
value entered for ‘Passcode’ matches with the ‘Supervisory Code’
for Reset Command set on Utility Page .
TOTAL RESET COMMAND
No
Yes
(Default : No)
The definition and operation of this parameter is same as that
described for the parameter ‘Passcode Value’ for ‘Min./Max.
Reset Command’, but applicable for ‘Total Reset Command’. Note
that the value set for ‘Supervisory Passcode’ is commonly
applicable for both ‘Min./Max. Reset Command’ and ‘Total Reset
Command’.
PASSCODE VALUE
0 to 250
(Default : 0)
This parameter is available only if ‘Flow Alarm-1 Type’ is selected
to other than ‘None’. If the Alarm Type is selected as ‘Process
High’, the alarm is activated whenever the measured Flow Rate is
at or above the set value. Similarly, if the Alarm Type is selected as
‘Process Low’, the alarm is activated whenever the measured
Flow Rate is at or below the set value.
FLOW ALARM-1 SETPOINT
User Manual
FLOREX
8
The definition of this parameter is same as that described for Flow
Alarm-1 Setpoint but applicable for Flow Alarm-2 Setpoint.
FLOW ALARM-2 SETPOINT
(Default :
For Process Low : 0 ,
For Process High : 1000)
0 to 30000
(Default :
For Process Low : 0 ,
For Process High : 1000)
0 to 30000

PPI FLOREX Specifications

General

Brand	PPI
Model	FLOREX
Category	Controller
Language	English