Precor Experience 800 User Manual

Level the treadmill
It is important to level the TRM properly every time you move it.
CAUTION
To eliminate movement, make sure the adjustable feet are in contact with the floor. Also, make sure that the unit sits on a flat surface. Adjusting the feet of
the unit cannot compensate for extremely uneven surfaces.
Important Adjust only one rear foot at a time. DO NOT extend the adjustable feet more
than 3/4 inch (2 cm). Adjusting the rear feet can’t compensate for extremely uneven
surfaces. If you can’t make the running surface level and stable, move the treadmill to a
more stable location.
1. Use a 3/4-inch open-end wrench to loosen the jam nuts on the rear feet and adjust
as needed to level the treadmill. Then retighten the jam nuts (see Figure 12).
Fig
ure 12
2. Plug the power cord into an appropriate outlet.
Important The treadmill requires a 20-amp individual branch circuit grounded per
NEC (National Electric Code) guidelines or local region electric code.
8

Precor Experience 800 Specifications

General

Brand	Precor
Model	Experience 800
Category	Treadmill
Language	English