Precor GEN06 Series User Manual

5. Remove the fasteners that retain the AC power cord clamp and remove the clamp.
Keep fasteners for replacement installation.
6. Disconnect the AC power cord from the input module.
7. Feed the end of the replacement AC power cord that mates with the input module
through its hole in the frame and firmly insert it into the input module.
8. Set the AC power cord clamp in its mounting position and install using the previously
removed fasteners.
9. Set the AC input panel in its mounting position and install using the previously removed
fasteners.
10. Plug
1
in the power cord and Switch the input power ON.
11. Verify treadmill operation per "" and return to service.
.See Also
"Replacement Procedures" on page 48
1
Device power cord connector or electrical cable male connector that is inserted into an elec-
trical receptacle "outlet" (also called the plug-in).
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 80
6 Replacement Procedures
Power Cord Replacement

Precor GEN06 Series Specifications

General

Brand	Precor
Model	GEN06 Series
Category	Treadmill
Language	English