Precor GEN06 Series User Manual

6. Slide the new Take-Up roller through the running belt and slide into position. Evenly
hand tighten the left and right Take-Up roller mounting bolts a few turns only.
7. Tension the running belt to specification and verify tracking, see "Running Belt Tension
and Tracking Adjustment" on page 45.
8. Replace the belt guard cover ensuring the tabs are firmly locked into position on the
Take-Up roller shaft, see "End Cap & Belt Guard Cover Replacement" on page 66.
9. Replace the end cap (see "End Cap & Belt Guard Cover Replacement" on page 66).
10. Replace the hood cover.
11. Verify treadmill operation (see Operation Verification) and return to service.
.See Also
"Replacement Procedures" on page 48
"Running Belt Tension and Tracking Adjustment" on page 45
"Running Belt and Deck Replacement" on page 81
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 87
6 Replacement Procedures
Take-Up roller Replacement

Precor GEN06 Series Specifications

General

Brand	Precor
Model	GEN06 Series
Category	Treadmill
Language	English