Precor P80 Service Manual

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 38
P80 System Test Menu Table
Test
Equipment
Description
Auto Stop Test
TRM Only
1 Touch
Auto Stop Test
, then Touch
START
.
2 The Auto stop test will start the belt at 1 mph; count will be
reset to 0, and then count up with each step.
3 Touch
STOP
to end the test. Touch 
BACK
to exit to
Systems Test
.
Belt Speed Test
TRM Only
1 Touch
Belt Speed Test
, then Touch
START
.
2 The belt will start a 0.5 mph, using the machine control
paddle to increase by 0.1 mph increments. The console will
display motor current as the belt speed increases or
decreases.
3 Touch
STOP
to end the test. Touch 
BACK
to exit to
Systems Test
.
Incline Test
TRM,
Open Stride
AMT
1 Touch
Incline Test
, and then Touch
START
.
2 Use the machine control paddle to change the lift. The
console will display the analog to digital (A/D) incline
position number, the incline position in percent of incline,
and the Glitch incline position.
3 Touch
STOP
to end the test. Touch 
BACK
to exit to
Systems Test
.
AMT Stride
Position Test
AMT Only
1 Touch
AMT Stride Position Test
and then Touch
START
.
2 The High, Low and Dynamic positions will be displayed.
The low position display shows the lowest position reading
achieved during the test. The high position display shows
the highest position reading achieved during the test. The
dynamic position display changes with current stride
position. At maximum stride length the low stride display
should read 0 and the high stride display should read 40.
3 Touch
STOP
to end the test. Touch 
BACK
to exit to
System Tests
.

Precor P80 Specifications

General

Brand	Precor
Model	P80
Category	Music Mixer
Language	English