© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 80
4 If the Status shows Connected and the IP Address is "all zeros", it will be necessary to either have the
P80 software assist in acquiring the IP Address (Recommended) or enter the IP address manually.
Touch Configuration from the Connectivity menu.
5 Touch on the radio button next to Automatic, and then touch SETTINGS.
Figure 58: Connectivity Automatic Screen
6 The P80 will attempt to connect to the network, and when successful will acquire the networking
information necessary for registration. If the console was already connected, it will skip straight to the
‘Network Settings’ screen and display the current network information. Once a good IP Address has
been acquired, the P80 can now be registered. Continue with step 12.
Note: Automatic configuration will make up the vast majority of all installations. If
the installation requires a manual configuration, you will be notified as such within
the installation paperwork. If a manual configuration is indicated, precede with
steps 7 - 11 only with assistance from the facilities IT personnel.
Manual Configuration Steps Only:
7 Touch CONFIGURATION from the Connectivity menu.
8 Touch on radio button next to Manual, and then touch SETTINGS.
To Next Page
Loading...
