SX™ Operator Manual
©
Original Printed in English
MACHINE OPERATION
SET-UP & OPERATION
Before attempting to operate the machine, please
carefully read and understand the entire operator’s
manual including the information under Important
Safety Information and Controls to obtain optimum
performance and a longer service life from the unit.
1. Make sure the machine is plugged into the proper
electrical supply and that all the factory shields are
in place.
2. Turn ON both power switches in the rear of the
machine.
3. The Language Selection Screen will display the
last language selected. If same language is used,
press OK.
4. If different language is desired, press on the Blue
Language Display button until correct language is
displayed.
5. Press OK.
6. Load film material as described under Loading
Bag Film.
7. Home the Jaw by pressing the Home Jaw Button
from the Dashboard or Service Screen 1.
8. Set Bag Settings in Settings Screen.
9. Cycle bagger once to position an open bag.
10. Load product into bag.
11. Initiate sealing cycle using one of three methods:
Foot Control plugs into back of machine.
Operator Controls
Setting the machine to automatically cycle.
2-4
To Next Page
Loading...
