SX™ Operator Manual
©
Original Printed in English
DEFINITION OF TERMS
Throughout this manual, you will find the following
safety notices with the accompanying symbol.
This symbol signifies important safety issues re-
garding the operation and maintenance of the
Sharp SX™.
SAFETY LABELS
The following label is placed onto the Sharp SX™
wherever a removable shield, or panel, guards the
heated sealing area. Always disconnect electrical
power from the machine prior to removing any guards
and/or panels.
The following label is displayed where there is the po-
tential of your hands, long hair, jewelry, etc., becoming
entangled between two rotating parts. Be sure to se-
cure loose items before approaching and operating
the machine.
The following label on the Sharp SX™ is located
where there is potential of injury due to pinch points or
moving parts. Make certain electrical power is discon-
nected before removing any guards and/or panels.
The following label is located in the proximity of a
fused circuit. Be certain to replace blown fuses ONLY
with fuses with the same electrical rating. Always dis-
connect electrical power before removing any guards
and/or panels and servicing the Sharp SX™.
The label shown below is located on the Sharp SX™
wherever a removable shield, or panel, guards electri-
cal components. Always disconnect electrical power
from machine prior to removing any guards and/or
panels with this label.
IMPORTANT SAFETY INFORMATION
IMPORTANT SAFETY INFORMATION
1-1
GENERAL WARNING. Indicates information
important to the proper operation of the equip-
ment. Failure to observe may result in damage
to the equipment and severe bodily injury or
death.
WARNING!
GENERAL CAUTION. Indicates information im-
portant to the proper operation of the equip-
ment. Failure to observe may result in damage
to the equipment.
CAUTION
To Next Page
Loading...
