Pregis SHARP SX - APPENDIX; Settings Summary

SX™ Operator Manual
©
Original Printed in English
This section list the range of each setting and an Initial
value if applicable. Note: The initial settings are only
applicable during the first time power up of the bagger.
Bag Length
4.00-20.00”
Initial: 6.0”
Seal Offset
Range: 0.00 – 2.00”
Initial: 0.00”
Seal Dwell
Range: 0.00 – 0.40 sec
Initial: 0.25 sec
Seal Cooling Time
Range: 0.00-2.00
Feed Speed
Range: 4.00 – 30.00 In/Sec
Initial: 10.00 In/Sec
Filler Drop Time
Range: 0.00 – 9.99 sec
Initial: none
Auto Load Dwell
Range: 0.00 – 5.00 sec
Initial: 0.00
Batch Counter
Range: 2 – 9999
Initial: 3
Parts Counter
Range: 1 – 999
Initial: 3
Print Speed
Range: 2.00 – 12.00 in/sec
Initial: 6 in/sec
Print Length
Range: 0.5-10.00 in.
Initial: 2 in.
Consecutive Bags
Range: 2-20
Initial: 2
APPENDIX
SETTINGS SUMMARY
6-1