Hardware and Software Settings 15
c. Cut or fold a 8.5" x 11" sheet of paper in half length wise so
that it is no wider than 4.25 inches. Pull the the label stock
guide all the way out and lock it in place using the
instructions in Section 2G. Push the paper into the feed
area. Once the printer senses the page it will pull it into
place. You must feed the test sheet of paper into the
printer after the alignment print has been sent to the
printer otherwise it will feed the sheet right through the
printer with out printing.
d. The printer will print the alignment test and scan it into
memory. Once the alignment is complete you will see a
confirmation dialogue box on your monitor. Click OK.
To Next Page
Loading...
Need help?
General
