6 Hardware and Software Settings
C. CONNECTING POWER
1. Locate the power adapter
supplied with your printer.
2. Place one end of the adapter
cord into the power port on
the rear panel of the printer.
3. Plug the power cord of the
adapter into an available
wall outlet or surge protect-
ing power strip. Once the power cord is connected, the
printer can be switched on and off using the power switch.
D. CONNECTING THE USB CABLE / INSTALLING THE
PRINTER DRIVER
Connect the printer to your PC
or Mac with your beige USB 2.0
Cable.
If you are using a PC:
If you are using a PC, after a
few moments, Windows will
tell you it has found new
hardware and is looking for
software to install it.
To Next Page
Loading...
