Printronix Auto ID T820 - Media > Handling

68
Media > Speed > Slew Speed Control
Controls how slew speed is chosen. By default, it will match Print Speed.
Automatic
Always the same as the print speed.
Manual
Allows you to set the slew speed independently from
Print Speed by unhiding the Media > Speed > Slew
Speed menu.
Factory
Automatic
Media > Speed > Slew Speed
When the Media > Speed > Slew Speed Control is set to Manual, this menu is
unhidden. The range and defaults are consistent with Print Speed.
Minimum
Same as Print Speed minimum
Maximum
Same as Print Speed maximum
Factory Default
Same as Print Speed
IMPORTANT
Only available when Media > Speed > Slew Speed
Control is set to Manual.
Media > Handling
Media > Handling > Print Mode
This option specifies the type of printing to be done.
Transfer
Indicates Thermal Transfer printing (ribbon installed).
Direct
Indicates Direct Thermal printing (no ribbon) and
requires special heat sensitive media.
Factory Default
Transfer