75
Media > TOF > TOF Adjust Mode
This option enables use of the Media > TOF > TOF Adjust Dist.
The TOF Adjust Dist menu value will not be used.
The TOF Adjust Dist menu value will be used.
Media > TOF > TOF Adjust Dist
This option sets the distance from the Top Of Form (TOF) that is left blank
(unprinted) after a label has been removed in Tear-Off Strip mode. When this
mode is enabled the start position for printing can be adjusted in increments
of 0.01 inch.
This adjustment can be helpful if a die cut label sticks to the platen by means
of jagged edges created during a poor die cut label removal using the tear
bar. By controlling how much blank space there is from TOF, you can control
how much the media is called back after it is torn off.
Media > Fault
Media > Fault > Label Missing
Allows the Label Taken Sensor to first detect the presence of a label at the
peel bar.
The printer does not generate a fault condition if a
missing label is encountered.
Peel-Off Handling: The printer generates a fault
condition if a full missing label is encountered.
Tear-Off Strip and Continuous Handling: If no label is
detected by the label taken sensor after the first 1.35
inches of motion, then a LABEL WRAP fault is
declared early.
Cut handling: Ignored
Peel-Off handing: The settings behave the same as
Full Label.
To Next Page
Loading...
