118
Chapter 3 PRINTER CONTROL
Power Saver Time
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode. When instant is chosen, the
printer goes into Power Saver mode as soon as printing stops.
Pressing any key removes the power saver message from the control panel.
Sending a print job to the printer also turns off power saver mode.
The options are 1, 5, 10, 15, 30, 45, and 60, and 240 minutes.
The factory default is 15 minutes.
Pwr Save Control
Pwr Save Control allows you to enable and disable Power Saver mode. If
enabled, the menu for Power Saver Time is in effect.
The options are Enable (the factory default) and Disable.
Display Language
This parameter chooses the language that will appear on the LCD: English,
German, French, Italian, Spanish, or Portuguese.
The factory default is English.
Del Char frm Fls
This option deletes downloaded character(s) from flash memory.
Ld Char from Fls
This option loads downloaded character(s) from flash memory.
Save Char to Fls
This option saves downloaded character(s) to flash memory.
Del Char frm RAM
This option deletes downloaded character(s) from RAM.
Ld Char at PwrUp
This option loads downloaded character(s) from flash memory at Power Up.
The options are Disable (the factory default) and Enable.
Del Set frm Flsh
This option deletes downloaded overlay set(s) from flash memory.
Ld Set from Flsh
This option loads downloaded overlay set(s) from flash memory.
To Next Page
Loading...
