Printronix T5000 - Ignore Chars; Ignore Mode; Ignore Spaces

180
Chapter 3 Emulation Submenus
Ignore Ch#2
(From page 143.) Specifies character 2 for the character filtering option. Valid
decimal values are from 0 through 255.
The factory default is 0.
Ignore Chars
(From page 143.)
• Disable. Character filtering is not enabled.
• Char 1. Character 1 will be filtered. Select the option “Ignore ch#1” to
specify character 1.
• Char 2. Character 2 will be filtered. Select the option “Ignore ch#2” to
specify character 2.
• Char 1&2. Characters 1 & 2 will be filtered. Select the options “Ignore
ch#1” and “Ignore ch#2” to specify values for these characters.
The factory default is Disable.
Ignore Dots
(From page 142.)
• Disable. The VGL expects position values to be specified in tenth inches
and dot rows.
• Enable. Causes the VGL to expect position values to be specified in only
1/10ths of an inch. If the dot position is also given, it is treated as text.
The factory default is Disable.
Ignore Mode
(From page 141.) This parameter instructs the IGP to ignore the character
selected under the Select Character menu.
• Disable. The IGP does not ignore any characters.
• Enable. The IGP ignores the character specified in the Select Character
menu.
The factory default is Disable.
Ignore Spaces
(From page 143.)
• Disable. Trailing spaces are not deleted from alphanumeric elements in a
graphics pass.
• Enable. Trailing spaces are deleted from alphanumeric elements in a
graphics pass.
The factory default is Disable.