Printronix T5000 - Page 147

147
Notes:
* = Factory Default
Italicized items are available only when you enable
Advanced User (in the PRINTER CONTROL menu).
1
All three Form Length submenus work in conjunction.
When you change the default in one submenu, the
other default values in the other two submenus
change automatically.
2
These menus do not display when the CT emulation
is selected.
3
The factory default value depends on the width of the
printer model.
4
All three Form Width submenus work in conjunction.
When you change the default in one submenu, the
other default values in the other two submenus
change automatically.
P-SERIES SETUP
(cont. from prev. page)
Text Position
(page 194)
Bottom of Line* Top of Line
Reset Cmd CFG Ld
(page 188)
Disable*
Host Command
(page 178)
Enable* Ignore All Ignore CPI
Form Length
(1)(2)
(page 174)
Ignore LPI
Power up config Current config Factory config
Form Length
(1)(2)
(page 175)
101.6 or 152.4 mm*
(3)
Form Length
(1)
(page 175)
Form Width
(4)
(page 175)
41, 66, or 85 characters*
(3)
0to272characters
00.0 to 609.6 mm
4 or 6 inches*
(3)
00.0 to 24.0 inches
24 or 36 lines*
(3)
0 to 144 lines
Form Width
(2)(4)
(page 175)
104.1, 168.0, or 215.9 mm*
(3)
00.0 to 345.4 mm
Form Width
(2)(4)
(page 175)
04.1, 06.6, or 08.5 inches*
(3)
00.0 to 13.6 inches