Printronix T8000 - Network > WLAN Params

201
Network > WLAN> BootP
You can enable/disable the BootP protocol using this option, but consult
your administrator for the appropriate setting.
Disable BootP is disabled.
Enable BootP is enabled.
Factory Default Disable
IMPORTANT
If changed, the printer reboots when it is placed
ONLINE.
Network > WLAN Params
Network > WLAN Params > SSID Name
A 1-32 character, case-sensitive string that identifies the Extended Service
Set Identification (ESS_ID) network the unit is parrt of (ESS_ID is also called
NET_ID). These characters can be alphanumeric, symbols, or spaces.
IMPORTANT
If changed, the printer reboots when it is placed
ONLINE.
Network > WLAN Params > Reset SSID Name
Allows you to reset the SSID name
IMPORTANT
If changed, the printer reboots when it is placed
ONLINE.
Network > WLAN Params > Min Xfer Rate
Allows you to set the minimum speed at which the Wireless Option will
accept a connection (inmillions of bits per second). The options are
Auto-negotiate, 1Mb/sec, 2Mb/sec, 5.5Mb/sec, and 11Mb/sec.
Minimum 1Mb/sec
Maximum 11Mb/sec
Factory Default Auto Negotiate
IMPORTANT
If changed, the printer reboots when it is placed
ONLINE.