86
Sensors > Control > Paper Out Sensor
Selects which type of media sensing, Transmissive or Reflective, will be used
to detect a paper out condition. The printer automatically selects the type of
sensing based on the Gap/Mark sensing selected as shown in Table 2.
Reflective Use reflective sensor for paper out sensing
Transmissive Use transmissive sensor for paper out sensing
Factory Transmissive
IMPORTANT
Whenever you select Transmissive, you must
position the upper media sensor directly over the
lower media sensor (see Positioning the Media
Sensors page 35).
Sensors > Calibrate
You can run Auto Calibration from the Home screen, this section, or the Tools > Print Tests > Run Test
menu. Upon execution, the printer advances media the distance needed to accurately detect the label
length indicators, then stops at the Top-of-Form position, and momentarily displays the Sensed Distance if
successful. This process takes a few seconds to complete and results in changes to the values the printer
uses in the Sensors > Control subsection for Gap/Mark Threshold, Paper Out Threshold, and Sensed
Distance. These value changes take effect immediately within the current configuration menu.
Sensors > Calibrate > Auto Calibrate
See Sensors > Diagnostics > Media Profile
Sensors > Calibrate > Power-Up Action
Calibration activities when the printer is powered up.
Disable No activities at power up.
Auto-Cal
Auto Calibrate is performed at power-up. Once the
Auto Calibrate is complete, the printer will momentarily
display the Sensed Distance determined by the Auto
Calibrate.
Seek TOF
Assumes user has already calibrated media and used
gap/mark sensor. This moves the media to
Top-of-Form at power up if Sensors > Control >
Gap/Mark Sensor is not set to Disable.
Factory Auto-Cal
IMPORTANT
If Media > TOF >Ticket Save Mode is set, Auto-Cal
and Seek TOF will not be performed.
To Next Page
Loading...
