Printronix T8000 - Page 87

87
SENSORS > Calibrate > HeadClose Action
Selects whether the printer performs a selected action after a print head open
fault condition is cleared.
Disable
No media motion after a print head open fault condition
is cleared.
Auto-Cal
Performs Auto Calibration every time the print head
open fault condition is cleared.
Seek TOF
Moves the media to TOF (Top Of Form) when the
printhead is closed unless Sensors > Control >
Gap/Mark Sensor is set to Disable.. The media should
already be calibrated using Gap/Mark sensor.
Factory Disable
IMPORTANT
If Media > TOF >Ticket Save Mode is set, Auto-Cal
and Seek TOF will not be performed.
If there is data pending (data in buffer) when the
head open fault is cleared, Auto-Cal and Seek TOF
are ignored.
Sensors > Calibrate > Online Action
Whenever the printer is brought ONLINE, it automatically performs an Auto
Calibrate if enabled. This option should only be set before any data is sent to
the printer.
Disable No Auto Calibration is performed when going ONLINE.
Auto-Cal
Once the Auto Calibrate is complete, the printer
momentarily displays the Sensed Distance and then
resumes printing any pending jobs.
Factory Disable
IMPORTANT
If Ticket Save mode is enabled, you will not be able
to enable this menu. A warning message will be
displayed instead.