Prinzen PSPC7 - Safety Regulations

INTRODUCTION
Page 10 of 99 USER MANUAL PSPC UM-PSPC-06-E/10-2012
GENERAL
This manual contains important information concerning safety, operation, cleaning, maintenance and
breakdown remedies.
At all time this manual must be accessible for all personnel working with the system. Keep it in a
permanent place, close to the system. When the manual is lost or damaged, order a new copy as
soon as possible.
The user of the system should read and understand the total user manual before operating, cleaning,
maintaining and repairing the system.
Never change the sequence of procedures as described in this manual.
Beside this manual also knowledge about the installation and adjustments of the system may be
helpful for communication with the Prinzen service department or dealer. This information is described
in the English-language service manual, which is also delivered with this system.
SAFETY REGULATIONS
Before starting operation, cleaning, maintaining the system or before remedying breakdowns first read
this chapter and chapter Safety.
LEGAL REGULATIONS
- All safety directions stated in this manual must be observed.
- Along with the safety regulations in this chapter the instructions of the qualified trade
organization of your country must be observed to avoid accidents.
- Before starting to repair or maintain the machine always consult your safety manager to
discuss if a work permit is required for this job.
- All safety devices in the machine and the safety indications mentioned in this manual are
conditions to control the machine safely. The owner and his qualified personnel are in the end
the ones responsible for the safe use of the machine.
- The owner is responsible for the ability of the qualified personnel to perform its duties
according to the safety measures.
- Technical changes, which influence the safety working of the machine, may only be executed
by the service department of Prinzen.
- Do not change controls, and/or PLC programs, without written permission from Prinzen
because this may affect the safety of the machine.
- Only use genuine Prinzen parts or CE-certified parts for replacement.
- Prinzen cannot be held responsible for any consequential damages to the system or other
installations that were caused by technical changes, unprofessional maintenance and repairs
on our system, which were executed by the customer.
- Warranty becomes invalid when consequential damages to the system, caused by technical
changes, unprofessional maintenance and repairs, were executed by the customer.
DANGER!
Failure to obey legal regulations may result in permanent personal injury or death.
ATTENTION!
Failure to obey legal regulations may result in damage to the system.