OPERATION
Page 48 of 99 USER MANUAL PSPC UM-PSPC-06-E/10-2012
CONVERSION
GATE OPEN/CLOSE
On a 7 rows system it is possible to run this
system with 5, 6 or 7 rows of eggs by closing
or opening gates on the sides of the packer.
When running 30-cells trays on this system
both outside gates are closed. See alongside
pictures for opening (1) and closing (2) of the
gates.
When the gate is opened place the pin (3) on
the shaking fork.
When the gate is closed place the guide (4) on
the shaking fork.
MOBILE OUTPUT CONVEYOR
REPOSITIONING
On a 7 rows system it may be necessary to
reposition the output conveyor towards (or
away from) the packer during a product
change over. In that case the output conveyor
is mobile.
Follow the below steps to reposition the output
conveyor:
5. Loosen the knobs that tighten the
output conveyor to the packer.
6. Reposition the output conveyor.
Position the holes of the support strips
above the correct threaded holes in
the beams.
7. Tighten the support strips to the
beams with the knobs.
To Next Page
Loading...
