SAFETY
Page 20 of 99 USER MANUAL PSPC UM-PSPC-06-E/10-2012
EMERGENCY BUTTON
To stop the machine in case of an emergency, the system has one or more emergency buttons.
Only use the emergency button in case of an emergency. When the emergency button is pressed, the
system stops immediately. The button stays mechanically locked so the machine cannot start until it is
considered safe to do so. Release the emergency button by turning it clockwise.
Do not release the emergency button when it is not certain why and by whom it was pressed.
Personnel working with the system must know the positions of the emergency buttons.
SAFETY INSPECTION PROCEDURE
Before starting the machine all protective covers must be in place, all doors must be closed and
emergency buttons must be operating. Trained personnel must check safety devices to assure proper
operation.
1. Check that all protective covers are in place and all doors are closed.
2. Start and stop the system.
3. Wait until the system has completely stopped and push an emergency button.
4. Push the start button, the machine should not start.
5. Pull the emergency button.
6. Repeat the above steps 3, 4 and 5 for all emergency buttons.
7. Make sure that the machine does not start when any emergency button is pressed.
If the machine operates when an emergency button is pressed, this machine is not safe to operate.
Immediately call a qualified technician to repair the defective safety switch or emergency button.
To Next Page
Loading...
