MAINTENANCE
UM-PSPC-06-E/10-2012 USER MANAUL PSPC Page 73 of 99
GENERAL MAINTENANCE PROCEDURE
Before actually starting to maintain the system, first follow below steps:
- See to it that all eggs and trays are removed by letting the machine run empty.
- Switch off the system and secure it against accidental switching on.
- Perform the maintenance.
- Check the condition of the system during maintenance.
TIP!
All motors are provided with lifetime lubrication and require no lubrication.
TIP!
All bearings are sealed and lubricated for life and require no lubrication.
Perform the maintenance according the advices and intervals as described in the Preventive
maintenance instructions further on in this chapter.
TIP!
The maintenance advices and intervals described in this manual are general. For your specific products and
production process the maintenance schedule may need alteration. During the first production months observe the
performance of the system and the influence of the maintenance and (if necessary) change the maintenance
methods and schedules.
AFTER MAINTENANCE
When the maintenance duties are finished, ensure the following:
- All fasteners are secure.
- All safety covers are in place and safety doors are closed.
- All tools and cleaning utensils are removed from the system.
- The system is absolutely dry before putting it back into operation.
- Moving parts that have been cleaned are lubricated.
- Excess lubricant is removed.
- The system is tested before starting production.
To Next Page
Loading...
