OPERATION
Page 66 of 99 USER MANUAL PSPC UM-PSPC-06-E/10-2012
SERVICE MENU SENSOR CONTROL
In this menu it is possible to disable the use of certain sensors. The system remains running without
the use of a disabled sensor. Switch a sensor ON or OFF by pressing F4.
After switching the system OFF and ON again, the sensors are enabled again!
Detection cell jumpers:
With this function it is possible to switch off an egg detection sensor above an infeed gate. The roller
track starts running even when no egg is present in the corresponding gate. Select the appropriate
sensor by pressing F6 and afterwards F1 or F2. Switch the sensor ON or OFF by pressing F4.
Cup detection:
With this function it is possible to switch off the cup detection sensor. In that case the system does no
longer check the correct transfer of eggs from roller track to cup conveyor.
Start transfer:
With this function it is possible to switch of the start transfer sensor. In that case the transfer arm
picks-up eggs after every 6 steps of the cup conveyor regardless of the presence of eggs. Eggs left
behind on the cup conveyor are not detected and will drop on the floor.
To Next Page
Loading...
