Prinzen PSPC7 - Page 55

OPERATION
UM-PSPC-06-E/10-2012 USER MANAUL PSPC Page 55 of 99
- The output conveyor is full with trays.
- Remove the trays from the output
conveyor.
- No tray is present at stopper position.
- Clear the fault
- Denester is switched OFF.
- Set the denester selection switch to ON.
- The movement of the transfer lever did not
finish in a certain time.
- This indicates a motor or inverter fault.
Contact your dealer for assistance.
- Optional automatic tray stacker (type PS2)
did not initialize correct.
- Press start to retry initializing. If message
remains on the screen this indicates a
motor or inverter fault. Contact your dealer
for assistance.
- Flaps are out of position or eggs, dirt or
parts are in between roller track and cup
conveyor.
- Clear fault.
Stacker fault press
start for retry
Check cup detection
flaps then press st
No Tray
Denester off
Transfer fault
Conveyor full