► SatCR commands:
By means of function SatCR it is possible to control the devices of a TV satellite
installation that are compatible with the SatCR (Satellite Channel Router)
technology, which allows to concentrate downlink frequencies (slots) by an only
cable. By this way each user using a slot can tune and decode any signal present
in the satellite.
Connect the RF cable (see Figure 6) to the RF connector for the input
signal of the equipment.
Press the Spectrum key to access the Spectrum analyser mode.
Press the Settings key and select the satellite band.
Select the polarization (horizontal/vertical) and the satellite band
(high/low).
If necessary, enable the Supply output and select the supply voltage
for the LNB.
On the Settings menu, select the option SatCR. It appears the icon
at the top right corner.
It appears the window with the configuration options.
Figure 52. SatCR command screen.
The screen shows the configuration options that user can modify: number of
slots, slot selected, device address, pilot signal activation (when activating the
SatCR device located in the headend, it emits a pilot signal with constant level
for each downlink frequency to identificate available channels), selected satellite
and frequency step. In other box appears the frequencies corresponding to each
slot.
8-90
April 2013
To Next Page
Loading...
