Cursor
Red vertical line that indicates position during the channel or frequency
tuning.
To change frequency/channel use the joystick (left, right) in FR mode
(tuning by frequency) or CH mode (tuning by channel).
Marker
It is a special cursor that can be placed on a given frequency to check the
power in this point.
To change use the joystick (left, right) in MARKER (MK) mode.
This option can be enabled using the "MARKER" option from the Advanced
menu (
key).
4.4
Joystick Operation in SPECTRUM ANALYSER mode
In the SPECTRUM ANALYSER mode, the joystick can make different actions
depending on its active mode.
The active mode of the joystick appears as an icon at the top right of the screen.
Available modes are:
► Frequency tuning.
► Channel tuning.
► SPAN change.
► MARKER moving.
To change the active mode press the joystick.
Figure 31.
Pressing left or right will take appropriate action according to the active mode.
April 2013
4-39
To Next Page
Loading...
