V/A Output Connector
The V/A output connector allows connecting a video/audio analogue output
signal. This connection allows you to switch between the image from the
equipment to an auxiliary monitor by following these steps:
Connect the jack 4V cable to the video/audio output connector
(
see figure 5), ensuring that the plug is fully inserted.
Connect the opposite end (RCA connector) to the auxiliary monitor
where video and audio of the equipment will be played.
Switch on the equipment and press the Settings key
for 1 second.
In the Video & Audio Settings menu, enable Video output.
Then, the image on the equipment disappears and the auxiliary
monitor shows a message asking for confirmation to switch the image.
Press the joystick to accept and the image will appear on the auxiliary
monitor. If you do not press the joystick after ten seconds the image
will return to the equipment.
8.3
V/A Input Connector
The V/A input connector allows connecting a video/audio analogue input signal.
This connection allows the user to view an image on the equipment screen
coming from an external source by following these steps:
Connect the supplied jack 4V cable to the video/audio input connector
(
see Figure 5), ensuring that the plug is fully inserted.
Connect the opposite end (RCA connector) to the source of
video/audio.
Switch on the equipment and select the terrestrial and analogue
signal.
Select TV mode
and press : Input.
From the menu, select “External”. A message shows that the external
input has been selected.
After a few seconds, the input image will be displayed on screen.
With the option : Aspect, you can select the aspect ratio of the
image, between 4:3 and 16:9.
8-88
April 2013
To Next Page
Loading...
