6.2.2
Operation
The LTE Ingress Test input is available to all DIGITAL TERRESTRIAL
signals.
To access the LTE Ingress Test tool:
Connect the RF input signal to the equipment.
Tune a digital signal of the terrestrial band.
Enter the MEASUREMENT mode or SPECTRUM mode .
Press the key (Tools).
Select the LTE Ingress Test mode.
Enable/disable the LTE filter pressing the key : Filter ON/OFF.
This function displays measurements obtained with LTE filter or without LTE
filter. Measuring the signal with filter or without filter is not done
simultaneously, but alternately, by means of the
key that enables or
disables the filter.
April 2013
6-59
To Next Page
Loading...
