6.6.2
Operation
The Spectrogram tool is available for all signals.
Connect the RF input signal to the equipment.
Enter the MEASUREMENT or SPECTRUM mode.
Select a channel or frequency.
Select the SPAN within the spectrogram will be displayed.
Press the Tools key
.
Select the Spectrogram option.
It shows the Spectrogram of the signal.
To exit this function press any key of mode (TV mode, Spectrum
mode or Measurement mode). All data registered is cleaned after
leaving.
While using the Spectrogram function, if the signal unlocks, timer and
measurement registered will clean and they will start to register when the signal
is locked again.
April 2013
6-69
To Next Page
Loading...
