13
MARK76V3002 Rev 3
Allow at least 48 hours to pass between each tanning session. Tan based on the exposure
sticker on the unit or in this manual. Skin Type I should not tan. As an owner you must
properly instruct all users on using the exposure table located on the front of the bed and
onlytanningfortheminutesbasedontheirskintype.Ifanynegativeeectoccurs,stopusing
the equipment and consult a physician.
Ifyouaretakinganykindofmedicationmakesuretorstconsultconsultyourdoctorbefore
tanning. Certain ingredients in medication can induce UV light sensitivity and cause allergic
reactions. A table describing a number of known allergens can be seen later in this manual.
For best facial tanning results make sure to remove all facial cosmetics thoroughly prior to
each session. Best results may occur if no cosmetics are used 3 hours or even the day of the
tanning session. If certain cosmetics are used you may experience a UV light sensitivity that
could cause an allergic reaction. See the table in this manual describing a number of known
allergens later in this manual.
Do not use tanning lotions, oils or gels that contain SPF ( sun protection factor) as these
couldhinderthedesiredtanningeectandmaynothavethesameprotectionwithtanning
equipmentaswithnaturalsunlight.Useonlythosethatarespeccallymanufacturedforuse
in tanning beds.
If your skin develops or displays any sort of undesired reaction such as a rash, acne, or
unusual dryness you should stop tanning immediately and consult your doctor.
Always avoid sunburn. If you overexposure yourself you could get a sunburn on your skin.
Should this occur, stop tanning and wait for the reddish color to subside before recalculating
your exposure schedule and resuming treatment.
Read the WARNING and DANGER label situated in full view of the user on the tanning bed
before beginning your tanning session.
Never use tanning accelerator pills in conjunction with your tanning treatement as these
could lead to an increase of skin sensitivity and sunburn.
Always wear protective eye wear.
Only (1) one tanner per session is allowed in the equipment.
The manufacturer cannot be held liable for damages or injuries from improper use of the
equipment or non-observance of the operating instructions.