EasyManua.ls Logo

ProSun V3 - Replacement of Components; General Replacement Warnings and Longevity; Lamp Disposal and Mercury Toxicity

ProSun V3
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
56
MARK76V3002 Rev 3
WARNING: Before doing any repair or replacement work on this machine, ALWAYS
disconnect the power at the main circuit breaker(or, if the main power cable has a wall plug,
pull it out).
IMPORTANT: Only use manufacturer-authorized replacement components. Failure to do so
many void warranty.
Longevity of the acrylic sheets
The acrylic sheets used in this machine should be changed between 1200 and 1500 hours of
operation. If not, UV-transmission could be greatly reduced.
Theacrylicsfortheunitareproducedofanacrylicglassdevelopedspecicallyfortanning
sesions. The use of other acrylic material can cause serious injury due to the incorrect
passing of UV radiation. The acrylics used in your equipment have a particularly high UV
permeabillity and resistance, ensuring that the user receives the correct UV radiation when
using the exposure schedule properly.
ProSun® recommends the use of Lucasol One Step when cleaning acrylic sheets. Acrylics
in tanning equipment are extremely porous and should not be cleaned/disinfected with non-
approved products.
Longevity of the lamps
Mostlampswilldisplayupto120%ofratedoutputduringtherst50hoursofillumination.
As such, exposure schedules should be reduced by 20%, or sunburning may occur. After the
initial 50 hours, the lamps will run at 100% of their rated output and gradually go down from
there, until about 800 hours, where upon the lamps should be replaced.
Disposal of Lamps
Tanninglampscontainuorescentmaterialsandotherwastethatcontainmercury.Certain
areasintheUSandCanadahavespecicregulationsondiposalofthesewastes,youcan
contactyourhealthdepartment,localgarbagedisposalcompanyorcityauthoritytondout
where and how to properly dispose of them. You should retain proof of proper lamp disposal.
WARNING!
Risk of mercury toxicity
Risk of mercury toxicity after lamp breakage. Ventilate the room or area at least 15 minutes
before disposing of the fragments.
Technical Modications
This unit has been manufactured in accordance with current safety regulations. The
illustrationsandspecicationsaresubjecttochangesinordertoimprovethedevice.
Unauthorizedmodicationsandchangestothedeviceanditscontrolsareprohibited.
ONLY USE ORIGINAL PARTS! Use of any other parts voids the warranty and ProSun will not
be liable in any cases of damage or injury due to the use of these parts.
Replacement of Components
WARNING!
WARNING!

Table of Contents

Related product manuals