Installation
IMPORTANT
:
• Read all instructions carefully. Failure to do so may result in a hazardous
condition.
• This unit is designed for use with 24 volt Multi-stage conventional heating and
cooling systems. Check the operating voltage of your system, and do not use this
thermostat with systems exceeding 30 volts.
• All wiring must conform to local and national electrical codes.
• Always disconnect the power supply during installation to prevent shock or
equipment damage.
• This thermostat should only be installed and used as described in this manual.
Any other use will void the warranty.
To Next Page
Loading...
Need help?
General
