Proteus DOLPHIN V4 - Pulse Recovery Function

E. RECOVERY (PULSE RECOVERY :
FUNCTION)
a. You can press RECOVERY button to the pulse recovery function
during start exercise or stop exercise mode, but except in the body
fat measure mode.
b. It is a function to check the pulse recovery condition after exercise.
Which is scaled from F1.0 to F6.0. While F1.0 means the best
and F6.0 means the worst. This function may reflect your heart
pulse recovery ability and help to improve it through exercise. In
order to get rate correctly, user must exam right after the workout.
After the button is pressed, please hold the heart rate detector
appropriately, the test will last for 1 minute and the result will show
on the screen. During the test, you can press the ENTER/MODE
button for 2 seconds to going out of the pulse recovery mode and
reset the monitor. After the tested, you can press any button to
jump out of the recovery mode.
B
O
D
Y
F
A
T
B
O
D
Y
F
A
T
N
W
O
D
N
W
O
D
E
E
N
D
T
M
O
E
R
/
E
E
N
D
T
M
O
E
R
/
P
U
P
U
R
E
C
O
V
E
R
Y
R
E
C
O
V
E
R
Y
R
EC
OV
ER
Y
Shows heart rate 102, the moment
you stop exercise.
Shows heart rate 86,
1 minute later.
Shows the result of the
detector measured.
19