Programming
General Information
The PTI Falcon uses a
menu driven programming
system which is easily
mastered. Individual
programming commands
are accessed by
function
number
. There are a total
of twenty function num-
bers listed on the pro-
gramming guide sticker on
the front of the base unit.
A copy of the program-
ming guide sticker is given
here for reference. To
access a programming
function, proceed as
follows:
Press "*".
(The display will read "Function? ")
Enter the Number
Press "#".
(The PTI Falcon will begin the selected Function)
If the programming guide
sticker is unavailable, it is
possible to scroll through
the available function
numbers on the PTI Falcon display. This is accomplished as follows:
Press "*".
(The display will read "Function? ")
Press "#".
(The display will move to Function #1)
If you wish to select a Function other than Number One:
Press "*".
(The display will move to Function #2)
Continue to press "*" until the desired Function Number is displayed, then:
Press "#".
(The display will begin the selected Function)
BASIC KEYPAD INSTRUCTIONS
PRESS * KEY, FUNCTION NUMBER, # KEY
OR PRESS * THEN # FOR HELP
1 - SET TIME/DATE
2 - SET BUS.HOURS
3 - SET HOLIDAYS
4 - SET BLDG SIZES
5 - ADD NEW UNIT
6 - SUSPEND UNIT
7 - RELEASE UNIT
8 - REMOVE UNIT
9 - SET 24HR UNIT
10 - SAVE ON TAPE
11 - LOAD FROM TAPE
12 - PRINT REPORTS
13 - ADJ. CONTRAST
14 - OPEN ENTRANCE
15 - SET MASTER CODE
(DOOR ALARMS ONLY)
16 - DOORS ON/OFF
17 - CLEAR ALARMS
18 - READ ALL DOORS
19 - UNK DOOR PRINT
20 - SET RELAY TIMES
PTI Access Controls · Summerville, SC
(800) 331-6224 · (803) 875-4994
To Next Page
Loading...