PTI Falcon - Function #4 - Set Bldg Sizes?

To Next Page

To Previous Page

Function #4 - Set Building Sizes allows you to classify your customers into Building groups.

A user of the PTI Falcon is identified by the combination of his Building number and his

Unit number. This function allows you to specify the number of units allowed in each

building. Units will be numbered in each building from one to the specified building size. If

the units in your facility are consecutively numbered throughout the facility or if the building

number is inherent in the unit number, you may wish to classify all customers into "Building

1" and not use separate building numbers.

As an example, suppose a facility has 300 units in three buildings as follows:

Building One: 75 units numbered 100-175

Building Two: 75 units numbered 200-275

Building Three: 50 units numbered 300-350

Then the building number is inherent in the unit number, and the largest unit number is 350

(even though there are only 300 units).

For the PTI Falcon, classify all units into one building group

as follows:

Then set the building size to match the largest unit number:

Now units on the facility will be numbered from 1-350 (even

though some numbers are not used) within building group 1. Even though this allows

access codes to be specified for all units that exist, it is typical to specify one extra building

group of a small size (typically 10) to which management access codes can be assigned.

Function #4 -

Set Bldg Sizes?

Building (1-32)

Number:

Bldg 01: 0000

New Size:

350