Maintenance
Technical Inspection
It is recommended to carry out a technical inspection before each use of the
device. Check the following:
• The device appearance (there should be no cracks on the body).
• The state of the objective and eyepiece lenses of the thermal imaging module
(there should be no cracks, grease spots, dirt or other deposits).
• The state of the rechargeable battery (it should be charged) and the electric
contacts (there should be no signs of salts or oxidation).
• The controls should be in working order.
• The thermal imaging module is properly and firmly fixed on the optical device.
Technical Maintenance and Storage
Maintenance should be carried out at least twice a year and include the
following steps:
• Wipe the exterior metal and plastic surfaces with a cotton cloth to remove dust
and dirt. To avoid damage to the paint coating, do not use chemically active
substances, solvents, etc.
• Clean the electrical contacts of the rechargeable battery on the device using a
non-greasy organic solvent.
• Check the eyepiece and the lens and if required remove dust and dirt from the
optics (preferably using a non-contact method). Cleaning of the exterior
surfaces of the optics should only be done with products specifically designed
for this purpose.
• Always store the device in its carrying case in a dry, well-ventilated space. For
prolonged storage, remove the batteries.
Troubleshooting
For technical support please contact support@pulsar-vision.com.
Answers to frequently asked questions about the devices can also be found in
the FAQ section.
To Next Page
Loading...
