Remote Control Activation
1. Turn on the Bluetooth module (see the Bluetooth section).
2. In the Bluetooth section of the menu, use the UP (5)/DOWN (7) buttons to
select the Scan menu item.
3. Confirm your selection with a short press of the МENU (6) button.
4. Press and hold any button on the Remote Control. The Remote Control is
visible in the Bluetooth network and can be connected during this time.
5. Use the UP (5)/DOWN (7) buttons to select the remote control from the
dropdown list that appears.
6. Confirm your selection with a short press of the МENU (6) button.
Notes:
• Once paired, the Remote Control can operate the Pulsar device.
• Going forward, the Remote Control will automatically connect to the paired
device when within visible range.
• The name of the remote control and its battery charge level will appear in the
list of paired devices at the bottom of the display in the Bluetooth section
of the menu.
To Next Page
Loading...
Need help?
General