USR-W630s User Manual
1 wired WAN port, 1 wireless WAN port, the WAN port is the wide area network interface;
Support DHCP client, static IP, PPPOE mode (only wired WAN port);
Default DHCP client;
The WAN port IP cannot be in the same network segment as the LAN port IP;
The network port of this WAN port can be set to LAN, which is convenient for customers to communicate
with multiple devices on the LAN. For specific settings, please refer to the network port mode
configuration.
4.1.1. DHCP Client
The upper-level router must enable the DHCP service, and use a network cable to connect the upper-level
router LAN and this wireless client WAN, so that W630s can obtain the IP.
Figure 11. DHCP Client settings
4.1.2. Static IP
Fill in the IP address in the same network segment as the upper-level router. The IP, gateway and subnet
mask must be filled in correctly. If it is a dedicated public network cable, the IP, subnet mask, gateway and DNS
server must be filled in correctly according to the operator's IP, subnet mask, gateway and DNS server.
To Next Page