CONTENTS
1. INTRODUCTION
6
2. SAFETY
7
2.1 Declaration of conformity 8
3. ACCESS LEVELS
9
3.1 User
9
3.2 Master / Manager User
9
3.3 Engineer
9
4. FUNCTIONAL DESCRIPTION
10
4.1 Operating Modes
10
4.2 Entry / Exit Mode
10
5. ZONES
11
5.1 Engineer Programmable Zones
11
6. DIAL OUT REPORTING
11
7. FUNCTIONS
12
8. INSTALLATION AND WIRING
17
8.1 PCB Layout
17
9A PANEL ASSEMBLY - Polymere
18
9A.1 Speaker Assembly
18
9B PANEL ASSEMBLY - Metal
19
9B.1 Tamper Switch 19
9B.2 Wall mountings / Holes 20
10. POWER CONNECTIONS
21
10.1 Mains Connection 21
10.2 Battery Connection
21
10.3 Bell, Strobe and Extension Speaker Connections
21
10.4 Remote Keypad 'RKP' Connections
21
10.5 Programmable Outputs
21
10.6 Digital Communicators
22
10.7 Auxiliary and Push to Set
22
10.8 Tamper
22
10.9 Tamper Connection for Bell Box's with Negative Removed Tamper
22
10.10 Shock Sensors
22
10.11 Double End of Line Resistor
23
10.11.1 Wiring Unused Zones in Double End Of Line
23
10.11.2 Wiring Two or More Sensors With End Of Line Resistors To A Single Zone
23
10.12 Telephone Connections
23
10.13 Battery Capacity
24
10.14 Powering Up The panel
24
10.15 Atlas End of Line Wiring Diagram 25
10.16 Atlas Double Pole Wiring Diagram
26
10.17 Atlas End of Line Wiring Diagram with Negative Tamper Return
27
11. ATLAS 8 PLUS LED - PROGRAMMING
28
11.1 Factory Defaults
28
11.2 Entering Engineer Mode
29
11.3 Setting Volume Control
29
11.4 Resetting The Non-Volatile Memory (NVM) to Factory Settings
29
11.5 Setting The Panel When Mains Fails
29
11.6 Programming Set Modes
30
11.7 Setting the Alarm Bell Time
30
11.8 Setting Entry Time
30
11.9 Setting Exit Time
30
11.10 Changing the Engineer Code
30
11.11 Programming Options
30
11.11.1 Programmable Output 1.
30
11.11.2 Programmable Output 2. 31
11.11.3 System Option 1 31
Rins163 Issue 9 Page 3
To Next Page
Loading...
