12.11.6 System Option 4
Enter followed by - . The RKP will toggle and X as the numbered keys are pressed.
Key Press
Display 1 2 3 4
Anti code reset enabled Open Zones Displayed Alarm on line fail -
STU
Alarm on line fail - PC
X
Anti code reset
disabled
Open Zones Disabled No alarm on line fail -
STU
No alarm on line fail -
PC
Enter to confirm programming.
12.11.7 Programmable Re-sets
Enter
followed by the number of re-sets required to ( = continuous re-setting)
12.11.8 Alarm receiving centre Telephone Number
Enter
followed by the telephone number. (Up to 16 digits)
By pressing the
a ", " is displayed to cause a 2 second pause during dial out.
Press
to store entry.
A number consisting of 16 digits will be stored automatically when the last digit is entered.
12.11.9 Alarm receiving centre Second Telephone Number
Enter
followed by the telephone number. (Up to 16 digits)
By pressing the
a ", " is displayed to cause a 2 second pause during dial out.
Press
to store entry.
A number consisting of 16 digits will be stored automatically when the last digit is entered.
12.11.10 Customer Account Code 1(Issued by Alarm receiving centre)
Enter
followed by the 4 digit code.
To use hex codes, use the up key to select the character required and the
key to accept.
12.11.11 Downloading Access Code
Enter
followed by the 4 digit code.
12.11.12 Zone Alarm reporting Codes
Enter
followed by 2 digits for each alarm zone. To disable an event insert blanks in place of the two digits.
To use hex codes, use the up key to select the character required and the
key to accept.
Example
Alarm zone 1
Alarm zone 2
Alarm zone 3
Alarm zone 4
Alarm zone 5
Alarm zone 6
Alarm zone 7
Alarm zone 8
For example to program alarm zone reporting codes 68 69 and 71 to zones 2, 4 and 7 respectively the following would be
entered:
Zone 1 Zone 2 Zone 3 Zone 4 Zone 5 Zone 6 Zone 7
Reporting codes are automatically stored after the 16th key press or by pressing the key.
Rins163 Issue 9 Page 51
To Next Page
Loading...
Need help?
General
