Setting and Un-setting the System
Entry Control
Using a Proximity Reader
There are two types of readers that can be used with the alarm system - the internal tag reader (used
for indoors only) and the external tag reader (used for both indoors and outdoors).
Tags for the readers need to be programmed through the ‘Edit Users’ function in the Master Manager
menu. The internal and external readers can be both assigned to individual areas, this will need to be
set up by your engineer.
Unset
Set
Unset
Set
Unlocked
Locked
Unlocked
Locked
The readers may be used for entry control, which means they can operate automatic locks for
example, as well as setting and un-setting the system. This can be set up by your engineer.
Entry Control Instructions
Arming: Present a valid tag to the reader, the GREEN LED will illuminate on the external reader,
remove the tag, the door will unlock, then present the same tag within 10 seconds and the system will
set and the door will lock.
Disarming: Present a valid tag to the reader and then remove it, the status will be shown (the alarm
symbol will illuminate indicating the system is armed on the internal reader and the RED LED on the
external reader), present the same tag within 10 seconds again and the system will be disarmed, and
the door will unlock. Once disarmed, the door can be unlocked.
Access Control/Entry Control: The readers can be used also for opening doors only without the ability
to set and unset. Please contact your engineer for more information on this feature.
PLEASE NOTE: Both the internal and external tag readers use the same proximity tags that are used
to set and unset on the keypad of the system.
To Next Page
Loading...
Need help?
General
