Setting the System
Un-setting the System
Using a PIN Code or a Tag
Using a PIN Code or a Tag
Enter a valid PIN code or present a valid tag to the ‘tag
symbol’ (which is to the left of the LCD screen).
Enter the area you wish to set, and press f. ‘Please
wait setting wireless’ will be displayed.
There are three different setting methods, your engineer
will demonstrate the appropriate exit method for your
installation:
Final Door: Once the exit time has started, leave the
building and make sure the exit door is opened and
then closed properly.
Timed: Make sure you leave the building before the
timer shown on the keypad expires.
Push to set: Press the push to set button installed by
your engineer to set the system.
Enter the building and the ‘entry time’ will start.
Enter a valid PIN code or present a valid tag to the ‘tag
symbol’ (which is to the left of the LCD screen).
Level Set System
Press f and the area that the code is assigned to will
be unset.
Area Set System
Select the area or areas you wish to unset then press
f.
PLEASE NOTE: If ‘flexi-unset’ is disabled then the
system will automatically unset the levels or areas set,
once a valid user code or tag is presented.
Enter Your Code
[*******]
ENTRY TIME [30]
Set Areas?
[A ]
Enter Your Code
[*******]
Please Exit via
Exit Route
EURO 46
Time 10:09 c
To Next Page
Loading...
Need help?
General
