Fault Indications / Unable to Set
Fault Indications
Chime
Omitting an Input
Unable to Set
Any faults that occur on the system will be easily recognised by the flashing ALERT LED.
To see what the fault is, enter a valid PIN code, present a valid tag, or press on the key fob.
Depending on how the system has been set up by your engineer, it may still be possible to set the
system despite a fault being present. To do this, enter your PIN code or present a tag, select the area
then press f.
PLEASE NOTE: Any fault may affect the overall performance of your alarm control panel and
therefore your engineer should be contacted for further assistance if any fault is active.
Unable To Set
Pantry Door
If ‘Unable To Set’ is displayed, it indicates that an
input is open and the area where the input is should
be checked for open windows, pets, movement etc.
If the problem cannot be solved contact your
engineer, or omit the input.
Advanced Functions
EURO 46
Time 10:09 c
The ‘chime’ can be used for any input on the system
and can be set up by your engineer.
To enable the chime on the keypad, when the time is
displayed, press c and ‘c’ will be displayed on the
right side of the keypad display.
Press c again to disable the chime feature.
Omit Day Al [01]
On occasion, a detector may need to be isolated if a
room is occupied. Enter your user code and press f
Once the exit time starts, press f then select the
inputs that need to be omitted. Press a. After 10
seconds the exit time continues.
PLEASE NOTE: Inputs have to be programmed as
‘omittable’ by your engineer for this feature to operate.
To Next Page
Loading...
