Your HomeControl+ App will
need to be authorised on the
Pyronix Cloud. Contact your
engineer if the message below
is displayed.
If connected successfully,
the below message will be
displayed and “Connected
to your system” will be briefly
displayed at the top.
The below screen will be shown
when connected. Please see
the next section for operating
instructions.
Setting and Un-setting the System
The below screens show how to set and unset using the HomeControl+ App. To disconnect from the
alarm system at any time, tap ‘Disconnect <System Name>‘ on the top menu bar.
Tap the open padlock to start
setting.
PLEASE NOTE: All areas that
show a green open padlock are
unset.
Once the system has set the
chosen area, a red closed
padlock will be shown. To unset,
tap the area that is set.
To unset after an alarm
activation, tap the red ringing
bell symbol. This will then show
the open padlock symbol and
the area is unset.
To Next Page
Loading...
